Originally Posted by
Mile High VX
How long ago did you make this mod? Any problems with the rear door sagging?
Right before the Moab 2015 VX meet....literally a couple weeks before b/c I didn't want to be caught out on the trail w/out a spare. So, 5 years at this point. Rear hinges are fine. I was rear ended last Aug, and the woman hit the spare tire while I was sitting at a stoplight in her 2015 Jeep Compass. She slid under the tire, and pushed the door in *very* slightly but it was enough that the angle of the tire wasn't parallel anymore. I have a spare door w/busted out glass sitting in the garage, but since it's just me during the coronas, and I didn't want to replace it, just get the angle right, I simply shimmed the 2 bottom bolts of the mount w/SS washers so the tire sits right. Her truck....however....over $3500 in damage. One of the main reasons I have it back there along w/the Curt hitch....taking a hit from a low sitting vehicle, the hitch will absorb that damage before the cladding gets damaged, depending on the speed of the impact. And the tire absorbs the hit from higher sitting vehicles, also protecting the cladding.
That and picturing myself climbing on top of the truck to get the spare in the event I need to....yeaaaah....no *lol*.
Oh, never sagged, no problems really, except the Tone hatch popper sometimes won't open the door all the way due to the extra weight. I'm going to be replacing the spring sometime in the near future, so that should remedy that.
Do you have a basket? I have one that's been sitting since I installed the bike racks + jack. It's the one everyone uses to attach to the VX cross bars. I put it up for sale a bit ago and this guy was trying to haggle so much over the price, I just stopped talking to him *lol*
Originally Posted by
ipd
I'd wager the hinges will be fine and can support the weight. If anything, the inside of the door might need some reinforcing, but that's no biggie. Overall, looks great! Though it does look a bit odd with the bump on the door with the tire outside now. lol!
You're correct about the hinges. The bolt heads are on the outside. Inside the door, I just used washers to distribute the weight a bit, then nylon inserted locking nuts. Merlin (IIRC) did this a bit ago, and did a write up, so I just basically copied what he did. And with the spare tire out of that space, it opens up a world of opportunities for the imaginative mind
Last edited by eternal21 : 05/25/2020 at 04:48 PM
www.thefundamentalelements.com