Results 1 to 3 of 3

Thread: poor oil viscosity

  1. #1
    Member Since
    Mar 2004
    Location
    2003 Jeep Liberty Limited
    Posts
    38
    Thanked: 0

    poor oil viscosity

    Just got back from the shop with the VX. Was going to do a few things to it this morning, but wanted to check the oil first to see how much it burned in the first 1000 miles since I bought it. There was no oil on the dipstick. I couldn't pull the plug as I did not have a socket big enough. I added one quart of oil and still nothing registering on the dipstick. Engine sounded fine and no oil pressure warning light. Drove it down the road to the shop. They pulled the plug and the oil that came out was the blackest, dirtiest that I have ever seen and extremely thin (watery). Supposedly the dealership changed the oil just 1000 miles ago (I have confirmed that some of the other services the attested to have indeed been done). I had the system flushed and a synthetic put in. It's running fine - quieter now than before. Any thoughts, oh mechanical gurus? Had the previous owner simply not changed the oil in the last 10,000 miles? Seems if that were the case it would have been tar and not water. Any thoughts would be appreciated. I'm ever mindful of those ill-fated 99's that have blown there engines after 60,000 miles. I'm sitting on 71,000. Isuzu's warranty is, of course, long gone, but I have a little time on the dealership's "gee, is you new-used car a piece of crap?" warranty. Thanks.
    Triple X

  2. #2
    Member Since
    Jun 2002
    Location
    1999, Ebony, VX, #1679
    Posts
    8,422
    Thanked: 3
    I would check the oil level frequintly over the next couple of months. If your VX continues to consume a lot of oil check this thread .
    Billy Oliver
    15xIronman
    My Sponsors:
    Accelerate3Coaching
    TriSports.com (PM me for 1 time use 20% off code)

  3. #3
    Member Since
    Mar 2004
    Location
    2003 Jeep Liberty Limited
    Posts
    38
    Thanked: 0
    Replaced the pcv today. BTW - I had pulled the Fram part number from one of the posts on this site, but had a hard time locating the part in my area (Atlanta). Pepboys, Autozone, Advance were all a no go for Fram pcv's. I bought a Deutsch, PCV193. Seems to be a good fit. Purolator's reference guide says PV1061 will fit the vehicross. I won't. Don't waste your $2.99.

Similar Threads

  1. Rear tires/axle misaligned -- a congenital defect or poor bodywork?
    By Grant Eaton in forum VX Troubleshooting...
    Replies: 21
    Last Post: 11/03/2008, 01:06 PM
  2. Poor man's photoshop, or I just rattlecan'd my VX.
    By MustangO4 in forum VX Modifications...
    Replies: 34
    Last Post: 08/06/2006, 03:11 PM
  3. Poor performance
    By SIRCO in forum VX Troubleshooting...
    Replies: 9
    Last Post: 11/16/2005, 10:51 AM
  4. poor gas mileage
    By geoffbear2003 in forum VX Modifications...
    Replies: 7
    Last Post: 03/23/2004, 09:12 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails