Page 1 of 2 1 2 LastLast
Results 1 to 15 of 21

Thread: P285/60R18's and wierd TOD Operation

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Mar 2003
    Location
    2001, Kaiser Silver, 0482
    Posts
    128
    Thanked: 0

    P285/60R18's and wierd TOD Operation

    Got my P285/60R18 Nitto Terra Grapplers installed last week, they are pretty awesome, looks are 10 times better and the handling feels about the same as the 255/60R18's I had before, and I push my VX hard. Ride is a little harsher but is expected since the air volume is greater (pnuematic stiffness overrides the extra section height benefits). I was concerned about being that wide on a narrow 7" rim, that handling would really tank, but its great. And just a bit noiser.

    Anyway, my TOD is now acting wierd. From a start, wet or dry, the TOD goes to full (3) leds then back to none, then back to (3) at least once or twice while accelerating. This is only around 0 - 20 mph and at part (halfway) throttle. Anything less and its the normal 1 led, anything more and it might spike to 3 then back to 2 as normal under full throttle (unless its really slick of course). I can physically feel the power going to the front and then all back as it cycles. At anything above 20 mph its good. I have no check TOD light flashing, I do have a TOD cutoff switch installed, but this just started with the tire change. Is the larger OD of the tires thowing off the TOD? Is there a way to reset the TOD or read codes? Is anyone else experiencing this with there larger Nittos?

    Thanks!
    Mike Skurich
    1969 C3 Corvette Coupe
    1988 C4 Corvette Coupe
    1992 Misubishi 3000GT VR4
    1997 BMW F650ST
    2001 VehiCROSS
    2002 BMW R1100S
    2005 C6 Corvette Coupe

  2. #2
    Member Since
    Oct 2002
    Location
    1153- ex owner
    Posts
    174
    Thanked: 0

    Thumbs up

    There is more voids in the tread. This is good for off-road and wet pavement . However the more voids in the tread pattern the less tread contact with the road. So there is a little bit more slippage when you first accelerate. I noticed the same thing with my Nittos. Other than that these tires rock off-road , on road at high speeds and at stopping on wet or icy pavement.

  3. #3
    Member Since
    Jul 2003
    Location
    2001, proton, 0310
    Posts
    136
    Thanked: 0
    Hi Vr-4

    I have the same set up 285's 7 in. rims Terra Grapplers...I have not noticed any difference with the TOD..I did drop the tire pressure (34lbs.) to soften that somewhat stiff ride...

    Very Very Very pleased with this tire/rim combination..I have had many people ask me about this tire...They seem to ignore the car and oggle over the tire Go figure

  4. #4
    Member Since
    Jun 2002
    Location
    Former owner of '01 Ebony #0739
    Posts
    1,579
    Thanked: 5

    Your TOD is working!

    No worries. I don't have the NITTO tires, but I've been having the same action due to switching to Pro Comp ATs. I could get the TOD meter to fully light up under hard acceleration on dry pavement even with the stock tires, and now it flickers every time I start to accelerate. The TOD system is adjusting for slipage as it's supposed to. I like watching the guage flicker like that... a reminder (as if I need one) of how wicked cool the VX is. Good times!
    The only thing we have to fear is fear itself... and zombies.


    My VehiCROSS

  5. #5
    Member Since
    Jun 2002
    Location
    2001, Ebony
    Posts
    439
    Thanked: 0
    I was just thinking the same thing. Same Tires on stock rims. Would TOD could something to wear out faster because of this issue with bigger tires w/less surface?

  6. #6
    Member Since
    Mar 2003
    Location
    2001, Kaiser Silver, 0482
    Posts
    128
    Thanked: 0
    OK, I can understand that, I notice now when I punch it from a start, I get all three leds easier since the tires have more void and slip, but this cycling up to three and then back down to 0, repeatedly, only at part throttle doesnt seem right. I cant get it to do it in reverse at all, only forward. Again, slight throttle and all is normal with 1 led, and then full throttle resutls in three then two and holds till I let off. And this cycling is at half throttle and low spee only in first gear, the the shift to second and its gone. Still need help, can i read TOD codes or something?

  7. #7
    Member Since
    Mar 2004
    Location
    2000 Firefox Red 0758
    Posts
    564
    Thanked: 0
    could the tires be 'mis-matched' ......... ??? ...... same sized tires, but the size is actually different ....... enough that is is driving the TOD computer crazy ............
    .
    maybe a sensor needs to be replaced or cleaned .... has some magnetic particles stuck to it .............
    .
    ......... could it be that when you 'punch' it, the TOD computer reads this and instantly sends the signal to send (more) power to the front wheels ........
    .
    I don't know - I never 'punched' my VX from a dead stop .........

    (hmmm, that's funny ........ I must be getting old ...... anyway, I get visions of the engine torqueing (rocking) on the motor mounts when I 'punch' it ....... and I don't believe there are flexible joints in/betwee/whatever the exhaust manifolds, so I will probably refrain from this .... I'm not up for replacing or repairing exhaust system components) ..........
    .

  8. #8
    Member Since
    Oct 2002
    Location
    '01 keiser grey #1193
    Posts
    87
    Thanked: 0
    since reading this I've noticed mine does the same thing. From a dead stop the tod will light up to three and back to one and back to three and then back.. quickly. I can't feel any slipping of the back tires . It used to light up with the stock tires .but seems to jump up and down now. Where it used to be up to three for longer time.
    VX...Priceless...Everything else there's mastercard..

  9. #9
    Member Since
    Mar 2003
    Location
    2001, Kaiser Silver, 0482
    Posts
    128
    Thanked: 0
    Jim, what tires are you running. Sounds exactly the same as what mine is doing. I would love to have my old tire around to convince myself its just the tires and nothing wrong with the TOD.

  10. #10
    Member Since
    Jul 2003
    Location
    2001, proton, 0310
    Posts
    136
    Thanked: 0
    Okay...now I figured out what the heck y'all were talking about.

    The "TOD" display is showing you a full load on full throttle situations..with these tires... right?...Well they also do this same thing with the stock skins too...they always have...you probably just never noticed it..

    This system is designed to sense traction coificients between front and rear tires. On pavement these conditions that go on between the front and rear wheels is subtle. To artificially exagerate this dynamic..just take your VX off road and challenge a very sttep hill and at slow enough speed that you can watch the interaction of an AWD system on the TOD meter. You will notice , by the seat of your butt, as the rear wheels jsut start to spin the "TOD" will load up to meet the increased demand.

    It is not magic...it is not even reallly very novel. It simply applies power to the front differencial when "it" thinks it needs it..Think of it as an ABS system in reverse..

    As the rear wheels start to spin( as in rapid acceleration) the TOD transfers this torque to the front wheels..these transfers are split second events. Thus, that's why it is hard for us all, except under the slipperest conditions to "light up" all four wheels with this car. BUT, the TOD meter, if you will, senses all this and automatically gets those front tires into the act...

    In short its not a problem..... , enjoy these tires...they are IMHO the best

    Actually, now that I think of it it is a 2 w/d system that converts to AWD as it senses conditions Now pull that lever on the extreme right and compound low overides the TOD and it stops sensing conditions around it and its a regular 4 w/d. Remembering, of course, that the front differencial is NOT a limited slip/equal lock/ or locking axle variety. The rear diferencial IS...so..I guess you could technically call it a 3 WD plus! Oh..who gives a ship! Still a "on fire" ride with the turning radius of a atv...

  11. #11
    Member Since
    Mar 2003
    Location
    2001, Kaiser Silver, 0482
    Posts
    128
    Thanked: 0
    No rocket man, that is not what I'm talking about. Yes, with my old tires I could get the 3 bars to light up when accelerating hard, even in the dry and especially in the wet. And yes, the new tires do the same, BUT, the new tires also light up all three bars even at half throttle in the dry, it repeatedly does 3 bars to 0 bars, 3 bars to 0 bars, etc. untill it hits second gear (it fluctuates up and down), which the VX never did before. It started with the tire change so I'm assuming it has something to do with them or is pure coincidence. It doesnt feel right at all, cause its dry pavement, I'm not accelerating hard, so there should be no slip yet its sensing it.

  12. #12
    Member Since
    Oct 2002
    Location
    '01 keiser grey #1193
    Posts
    87
    Thanked: 0
    yeah. before 3 bars would stay lit up till I was off the accelerator and back to one bar. I also noticed it will spinn the back right if I pull out quickly now when before it would never spinn. it is very brief scratch. I had this problem when the fuse was blown on the tod. but it was very extrem then.

  13. #13
    Member Since
    Jul 2003
    Location
    2001, proton, 0310
    Posts
    136
    Thanked: 0
    Yeah, well you guys may, indeed, have a problem. I suppose, if it is under warranty, you could take it in and have it checked out...The Nittos and the Pro-Comps have been put on by quite a few VX's owners that post on this site and I don't believe I recall any problems posted such as you report.

    Presuming your tire diameters are all four the same Technically, I can think of no reason these tires by themselves would cause some abberation in the TOD system. So a trip to the dealer might be in order.

    FYI... I owned an auto transmission shop out here for many years and I fixed mucho 4wd systems, though never a system like this

    John

  14. #14
    Member Since
    Oct 2002
    Location
    '01 keiser grey #1193
    Posts
    87
    Thanked: 0
    I think its ok....I went out on a newly cut road , Loose dirt very steep , Went up it no problem Tod would light up 3 lights and stayed up till I made it to the top. Didn't slip much. all 4 wheels pulled. No problem . It was so steep My buddy wanted to get out and just watch . He was worried about flipping it. I didn't give him time to get out... Locked it in to low 4wd and went through a good ditch. no prob. Seems to work fine.

  15. #15
    Member Since
    Jul 2003
    Location
    2001, proton, 0310
    Posts
    136
    Thanked: 0
    Good...the ole steep dirt road test always works!!

Similar Threads

  1. Operation: OVERLAND VX
    By Ala5ka in forum VX Modifications...
    Replies: 75
    Last Post: 11/03/2013, 09:20 PM
  2. Operation AWOL
    By ZEUS in forum Chit-Chat ...
    Replies: 35
    Last Post: 10/20/2010, 09:53 AM
  3. 18x9 Rims. 275/60R18 Geolanders only tire?
    By RallyDude in forum VX Modifications...
    Replies: 12
    Last Post: 04/15/2010, 08:04 PM
  4. egr operation.....
    By IndianaVX in forum VX Troubleshooting...
    Replies: 5
    Last Post: 03/06/2007, 01:27 AM
  5. P285/60R18 Trimming Photos
    By VR4-Quest in forum VX Modifications...
    Replies: 2
    Last Post: 04/05/2004, 08:31 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails