Here's some basic steps but if you want more setailed info, do a search through the archives:
passenger side (battery side):
1. Remove the electrical plug by reaching behind and dig deep into the rubber boot where the wires run through. Feel for a plastic plug clip, pinch hard, and pull back. The plug should come out with some effort.
2. Once wire plug is removed, then find small rubber tab on the rubber boot and pull back. Boot should slip off the housing.
3. You'll see the prongs of the bulb being held in place with a wire clip. DO NOT REMOVE THIS CLIP as it is a pain to put back in place. Best is to use needle nose pliers, grab the end of the wire clip near the slot opening and "undo" the clip. The bulb will then come un fastened and can be removed.
4. Replace the bulb and do everything stated above in reverse.
driver's side:
1. Remove the entire air box and components to gain access the bulb.
2. Follow the same instructions as above.
Estimated time (first time around) approx. 2 hours. After much practice (3rd/4th time), 20 minutes total.
Good luck and don't panic.
For custom VehiCross skidplates and accessories, check out:
www.aftershockproducts.com