SCer idler pulley

[newthings]

And another?
Could you draw it up and get a shop to make 10?
Nice job.
Thanks, Roy

[Hotsauce]

I could make more easily, I do this for a living.

BTW..Been eyeing this as an upgrade once I'm satisfied it all works.

http://cgi.ebay.com/ebaymotors/ws/eB...m=140420699615

John C.

[newthings]

So the pulley shown on EBAY with yolur spacer will do the trick?
Roy

[Hotsauce]

If mine works, I see no reason why that one wouldn't.

I won't be trying this till the weekend, then I'll know. I had to do the backspace by guess, since my pulley totally nucleated I don't know yet if its right. I don't know the original measurement from back edge of stock puley to mounting plate.

John C.

[Hotsauce]

Happy to report that this works as planned.

There probably is an idler pulley out there that is a direct replacement for ours with no bushings or spacer needed. For some reason they wouldn't let me go through the shelves at the parts store and open every box to find one.

When your pulley goes bad it will eventually sieze as mine did, and throw the belt. You won't get stuck, the engine will still run, just stock power.

As it looks like there is some need/interest in this, I will make up a few for those that need. I'm planning on only making 1 run of this, so if you want one tag up and say so. Materials, labor, and US postage, I think $40 will cover me. You will buy your own replacement pulley.

I'm going to let this sit a couple weeks untill anyone who wants chimes in, then run them all at once.

John C.

[Ldub]

I'm going to let this sit a couple weeks untill anyone who wants chimes in, then run them all at once.

John C.

Two of these.... and one of these

For You John...

I'm in for one bushing/spacer.

PM me the details when the time comes...

Also, sorry if this a dumb question, but would this work as well as the other billet one you listed?

Looks like not as pretty, but otherwise same-same?

[johnnyapollo]

I'm good for one as well...