Results 1 to 6 of 6

Thread: Ball Joint?

  1. #1
    Member Since
    Oct 2004
    Location
    2001, ebony, VX, 0982
    Posts
    93
    Thanked: 0

    Ball Joint?

    OK, I have this annoying squeek coming from the front and maybe rear supension? Every single little crack/bump/curve i will hear this squeek it is driving me nutz!!!! SPAZZ thought it might be a ball joint. I only have ball joints in the front right? how much are new ones? can i replace this myself? what tools would i need?

    Any Suggestions?

  2. #2
    Member Since
    Sep 2004
    Location
    1999, Astral Silver, VX, 0938
    Posts
    1,127
    Thanked: 0



    Not sure what it could be, drive around with some WD-40 and test an area at a time. I here ya about driving you nutz. Is that you above??? Good luck..
    [SIGPIC][/SIGPIC]
    " Jeeps are nice, Barbie has one"

  3. #3
    Member Since
    Jun 2002
    Location
    1999, Ebony, VX, #1679
    Posts
    8,422
    Thanked: 3
    Dirt + bushings = squeek

    Just turn up your stereo....no more squeek!
    Billy Oliver
    15xIronman
    My Sponsors:
    Accelerate3Coaching
    TriSports.com (PM me for 1 time use 20% off code)

  4. #4
    Member Since
    Jun 2002
    Location
    2001 Proton VX 0790
    Posts
    801
    Thanked: 0
    Jack up the front by the LCA, wiggle the tire and see if there is loose movement. if you find any, be sure its not wheel bearings before you blame the ball joint. They are easily changed, but about $60 each.

    Squeeks are more likely bushings or dead shocks.

    John C.

  5. #5
    Member Since
    Sep 2002
    Location
    1999SilverVehicross1534
    Posts
    48
    Thanked: 0
    Try oiling your hood latch and points of contact.
    My VX was sqeeking like freaking crazy and was driving me crazy as well. I thought it was a squeeky suspension too. Then I read on here about greasing up the hood latch and it actually resolved the issue. I have to grease it up every couple of months or the squeeking comes back.
    Last edited by Radiologue : 11/13/2004 at 03:49 PM


  6. #6
    Member Since
    Jun 2002
    Location
    2001, Proton Yellow, #0580
    Posts
    1,887
    Thanked: 5
    The sway bar bushings will collect crud and cause a squeek when the body rolls a bit. You can get some Energy Suspension bushings and brackets that have greasable zerks - packing grease in there will stop them from squeeking. Make sure that's the cause though.

    -- Best, John
    John Eaton
    Original Owner
    2001 Proton Yellow #580
    Atlanta GA

    http://wildtoys.com/vehicross/
    http://vehicross.blogspot.com/

    "Metaphors be with you"

Similar Threads

  1. Ball Joint Flip - Did you do it? Why? Why Not?
    By taylorRichie in forum VX Modifications...
    Replies: 10
    Last Post: 02/05/2016, 09:07 PM
  2. Ebay ball joint kit
    By mattferguson14 in forum VX Talk...
    Replies: 4
    Last Post: 01/29/2015, 02:08 PM
  3. Ball Joint Replacement
    By JHarris1385 in forum VX Troubleshooting...
    Replies: 27
    Last Post: 10/28/2014, 11:59 AM
  4. Replies: 6
    Last Post: 07/18/2014, 09:39 PM
  5. Ball Joint Flips
    By TucsonVX in forum VX Modifications...
    Replies: 8
    Last Post: 06/12/2003, 03:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails