been wanting to do this stuff for a long time, finally got to most of it..still have a few things left, but heres what ive done so far:

finally got the piaa fogs wired in , ended up having to replace a brand new relay (grrr) , and i cut the piaa switch into the spare block out plate by the hazard button..still needs some finishing, but not bad..

I installed turning lights in the side larker side housings. I used parking light sockets i found at the salvage yard some time ago (isuzu even!) , drilled out the holes, notched them with my dremel and bingo, factory looking fit.

I installed one super hi output white LED
(with resistor) in each of the front lower turn signal housings,wired up to the parking lights. it gives them a cool amber glow. More than bright enough to do the job.
shows where i installed the led, there was already a chanel there, not sure what the original purpose of this was, but i used it..


soldiered the ground right to the directional light housing:


fogs, and leds (directionals on side markers didnt photgraph well: )