Hood corner lifting up?

[Edward]

Anyone had this trouble..? One corner of the plastic insert (passenger side close to windshield) coming loose from the base and starting to raise up. Glue attachment or what??

[psychos2]

they used glue to attach to metal discs that rust and seperate.i removed the insert and reglued with some 2 part epoxy. make sure it is fast drying or it will run and not stay in the spot you need it to. shawn

[Joe_Black]

Remove the christmas-tree fasteners (use a trim tool) holding the underhood insulation and take a look at your insert retaining nuts. They may have loosened on that corner or either pulled free from the ABS insert.

[thebear54]

I agree...a two part Epoxy is the best remedy for that little fix.

FOR GOD SAKES DON'T USE CRAZY GLUE
John

[Edward]

Thanks for the help!

[Ldub]

This may be way too "industrial" looking for most & so far it's just a random thought. What does anyone think of removing the stock fastening posts on the insert, drilling through some or all of the former post positions & refastening with stainless cap screws w/ washers through the orig. mounting holes in the hood? You could even incorporate a couple of hood pins.
It would make insert removal for drainhole cleaning way easier.

Inquiring minds wanna know. Ldub

[Edward]

Probably because it took only 5 minutes to fix it with the two part epoxy and a little sand paper... But, good idea if you have the time.

[TDAWG]

I had the same problem a while back and used Gorilla Glue. I took it off for a day. Haven't had the problem again. it's been almost a year since it happened.