Page 1 of 2 1 2 LastLast
Results 1 to 15 of 22

Thread: Transmission mode switch, right?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Member Since
    Feb 2003
    Location
    1999, white, vehicross (iron-man edition), 0632
    Posts
    16
    Thanked: 0

    Transmission mode switch, right?

    Okay, I've been reading all the threads from the past 3 years about transmissions clunking between 2nd and 3rd gear. I understand that the problem is most likely my mode switch/ selector. I have 32,000 miles on my VX, and I did just have the tranny serviced/ flushed, etc. People's Isuzu here in Las Vegas quoted me $178.82 for the new mode switch; St.Charles Isuzu quoted me $121.88 (Thanks for the number Tone!). St. Charles called the part a position switch. Is this the same part as the mode switch? I've also heard it called a mode selector, and then I have heard of a mode switch connector. I believe the mode switch connector is an additonal piece. If you buy a new mode switch, does a new connector come with it? Could one part be bad, but not the other? I would hate to order one part, replace it, then still have my tranny clunk. It doesn't happen all the time, but you know, I'm sure that the hard shifting is bad for my transmission. Any additional info would be greatly appreciated even though great people like Tone, Anita, and Joe Black have commented on this problem before. Thanks. JL
    Last edited by Lampster : 08/29/2005 at 10:36 PM

  2. #2
    Member Since
    Jun 2004
    Location
    99 Astral Silver VX #1872 + 99 Ironman WIP
    Posts
    10,613
    Thanked: 1

    Arrow

    Are you the first owner? If not, a previous owner may have installed a trans. interceptor. This would account for the more aggresive (read clunk+kick in the pants) shifts. If that's the case, it can probably be adjusted.

    Ldub

  3. #3
    Member Since
    Feb 2003
    Location
    1999, white, vehicross (iron-man edition), 0632
    Posts
    16
    Thanked: 0
    Ldub, thanks for the info. I am the 2nd owner (the 1st gave him up for adoption) and as far as I know, there is not an interceptor on the transmission. I have had the VX for 2 1/2 years now, and this just started a month or two ago.

  4. #4
    Member Since
    Jun 2004
    Location
    99 Astral Silver VX #1872 + 99 Ironman WIP
    Posts
    10,613
    Thanked: 1
    Kinda shoots my theory in the foot :homer: ...oh well, hope someone around here will be of more help.

    Ldub

  5. #5
    Member Since
    Jun 2002
    Location
    2000 Ebony VX #263 ****** VX-2 My weekend car
    Posts
    2,067
    Thanked: 7
    I looked up my service invoice for the mode switch replacement. I had the really violent jerking going on when the truck shifted between gears.

    ********************
    Cause: Internal Failure
    051414D R&R Inhibitor switch
    76 WI
    8-96017-511-0 Switch, Position


    FC:44
    Part#: 8-96017-511-0

    49610 Mode switch internal failure, etc...

    "Performed scan tool diag. found DTC P0705. Performed Diag. trouble tree found mode switch to have internal failure. Replaced mode switch cleared code and road tested vehicle. Trans shifting correctly at this time"
    ***************************
    I do not know what the cost is. At the time it was covered by warranty. My mechanic said that he saw the mode switch fail on VX's with as little as 20K to mid 40's.
    Anita
    2000 Ebony #263
    Original Owner- love her too much to part with her.
    AnitaProtich.com

  6. #6
    Member Since
    Feb 2004
    Location
    '01 Ebony #0830
    Posts
    1,097
    Thanked: 0

    Hey fellow LV'gan!

    Hey there, I'm in Henderson... I had the same problem about a year ago and replaced the mode selector with total success! If you want, pm me and maybe we can hook up and I'll check out your VX's symptoms to see if they are the same as mine were. (or is yours as sporatic as mine was?)... anyhow, it'd be cool to meet you!
    ---JIM---
    SilverBullet75
    Formerly: '01 Ebony VXSTLTH
    Now: '08 Saab 9-7x Aero 6.0L

  7. #7
    Member Since
    May 2006
    Location
    SOLD!
    Posts
    7,257
    Thanked: 2
    Quote Originally Posted by Ldub
    Are you the first owner? If not, a previous owner may have installed a trans. interceptor. This would account for the more aggresive (read clunk+kick in the pants) shifts. If that's the case, it can probably be adjusted.

    Ldub

    Hey, I just posted a new thread about a similar "kick in the pants" shift. I thought it was from 1st gear into 2nd, but maybe it is 2nd to 3rd. It happens right around 20 mph. I am a brand new owner, I've had it for 3.5 days only, and I took a short drive (about 3 miles) where the trans was clunking like this. Then I stopped the truck, took a lunch break and drove back to work with no clunking. Hopefully this isnt a huge problem. Gaaaad I hope not!

    Bart

  8. #8
    Member Since
    Jun 2002
    Location
    '99 Ebony Black VX, 0339
    Posts
    2,073
    Thanked: 0
    Another indicator that it is the Mode Position Switch is that the light illuminating the shifter position on the dash will go dark.

  9. #9
    Member Since
    Aug 2003
    Location
    2001,White,Rodeo Sport,
    Posts
    139
    Thanked: 0
    Quote Originally Posted by Tone
    Another indicator that it is the Mode Position Switch is that the light illuminating the shifter position on the dash will go dark.
    I've had that happpen, the fuse would blow for the tail lights and the dash selector goes dark. Shifts like crap, really hard until the fuse is replace. Took it in once, the mechanic was kinda dumbfounded. Later the problem went away. So the mode position switch is the culprit?

  10. #10
    Member Since
    Jun 2002
    Location
    2000 Ebony VX #263 ****** VX-2 My weekend car
    Posts
    2,067
    Thanked: 7

    Post

    Quote Originally Posted by volume311
    I've had that happpen, the fuse would blow for the tail lights and the dash selector goes dark. Shifts like crap, really hard until the fuse is replace. Took it in once, the mechanic was kinda dumbfounded. Later the problem went away. So the mode position switch is the culprit?
    Interesting thing is with your tail lights going out as well, it sounds like a wire grounding out. I havent heard of the mode switch affecting tail lights. Several of us had the tail lights and dash lights go out only to find that there was a wire grounding out behind and below the drivers side headlight where a wiring harness runs which blew the corresponding fuse.

    I believe the mode switch going out can affect the shifter position lights... not the whole dash.

  11. #11
    Member Since
    Aug 2003
    Location
    2001,White,Rodeo Sport,
    Posts
    139
    Thanked: 0
    My dash lights were fine actually. The only thing that was affected was the shifting (rough), the selector lights on the dash were blank, and the 15A fuse for the tail lights blows out. This happend on and off for a little while and then suddenly stopped and went away. This is on a Rodeo Sport btw. I figured it was a loose wire somewhere but looking for it might take forever.

  12. #12
    Member Since
    Jun 2004
    Location
    VX Adopted Out. 2005 BMW 325CI & 2006 4Runner.
    Posts
    1,330
    Thanked: 0

    Cool My Proton is confused...

    Anita,

    The part number (above) is of much help. thx.

    Everywhere on this site people refer to this part as the "mode selector switch", etc... However, when I put the part number you provided into isuzuparts.com it comes up as a "NEUTRAL SAFETY SWITCH, Vehicross".

    Is the "Neutral Safety Switch" the same thing as a "Mode Selector Switch"?

    Thanks.

    -biju.
    *

    He lingers -- happily -- in a new hybrid state of semi-hormonal adolescence and responsible self-reliance.


    *

  13. #13
    Member Since
    Mar 2010
    Location
    1998,black,
    Posts
    11
    Thanked: 0
    is there a nother name for the mode selector switch as i cant find one on the net to buy cheers micknorm

  14. #14
    Member Since
    Jun 2004
    Location
    99 Astral Silver VX #1872 + 99 Ironman WIP
    Posts
    10,613
    Thanked: 1

    Wink

    Quote Originally Posted by chez View Post
    is there a nother name for the mode selector switch as i cant find one on the net to buy cheers micknorm
    http://search.mywebsearch.com/mywebs...AA%3D%3D&ct=AR

  15. #15
    Hey I found this it may be worth a try. http://isuzufaq.ibctech.ca/range.pdf I had to buy a new one and Isuzu does call it neutral switch. Part NO# for 2000 Isuzu rodeo / Honda Passport … 896 017 5110

    Hpoe this helps

Similar Threads

  1. Mode Selector Switch & Power Switch
    By ahdoman in forum VX Troubleshooting...
    Replies: 6
    Last Post: 11/20/2014, 11:34 PM
  2. best place to buy mode selector switch??
    By bearandbee in forum VX Troubleshooting...
    Replies: 11
    Last Post: 06/28/2012, 11:10 AM
  3. Mode Selector switch and how to kill yourself.
    By Ebenezr in forum VX Troubleshooting...
    Replies: 4
    Last Post: 01/13/2011, 01:08 PM
  4. ok the MODE Position Switch didn't work.
    By CoastieCosta567 in forum VX Troubleshooting...
    Replies: 10
    Last Post: 12/04/2007, 05:30 PM
  5. My mode position switch came in today!!!
    By VXIRONwoMAN in forum VX Talk...
    Replies: 42
    Last Post: 07/26/2007, 04:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
$lv_vb_eventforums_eventdetails