Interceptor Adjusted

[Hotsauce]

After a few tweaks I have the Interceptor adjusted to my liking. I'm at full delay, and about 40-45% line pressure. I know, some of you'se have gone with 75% pressure. After reading that I started there, and then down to ~60. The part throttle upshifts were annoying, and it banged the U joints loudly when it downshifted to 1st on decelleration.

Of course, now that it's right, I want to mess with it. I'm thinking of unsoldering the trimmer, and running it remote on the dash with a knob

[Tone]

That’s a good idea! Or simply set it higher and switch the power on and off to it when you want to use it.

I asked about putting 2+ Interceptors inline and although they had never done it, did say you would get some cumulative effect at least on line pressure. The delay is a pure time based thing and so both would be seeing the same time.

I am in the middle of getting pressure readings for them for off, .25, .50, .75 and 100% boost of line pressure. Should have some figures later this weekend.

t