shifter mods

[etlsport]

I've finally got time/money to finish upgrading my shifters, I'll probably go with a razo shifter, or similar, for the manual look, which means ill want to put a shift boot over the AT shifter. those of you who have done this, any tips or things i should know before I buy/ start installing the boot?

[etlsport]

also, anyone whos changed out their stock shift boot for the 4wd willing to sell the stock/ know if it would fit over the AT?

[Navigator]

Here is a pic of my set up. Got the boot & knob out of an old Trooper and/or Rodeo, your price may vary, got mine for free

[etlsport]

definately like the way the boot looks a lot more than the gear display, especially with one on the dash already. how did you attach the boot to the underside of the console? i havent had the chance to really look yet, but its always helpful to start looking with a few ideas to begin with

p.s. where is bemo? or would that be baltimore... i bought my vx in frederick md, and have it down there once or twice a month

[Navigator]

1. remove knob

2. remove console

3. slip on boot

4. re-install console & knob


There will be plenty of boot material to give it that baggy look, tweak it from above until it looks right, then tighten up the console. The console holds the boot in place. It's really that simple.

[etlsport]

have my shift boot now.. im just looking for a good auto shifter, anyone know where to get a low priced push down shifter (like the RA94 w/ no button) i love the look of not having a button.. but also dont want to pay 50+ for the knob.. or how complicated would it be to take a manual shifter and add a spring to make it work like the RA94