Finally got 'er loose (My 2 year old had fun whacking at it with me).

But when I did, I ran into more problems... when it dropped it stripped some of the threads at the bottom end of the BJ shaft, so when I went to put the castle nut back on it got about half way started and began turning the joint.

I took BJ off of the upper arm, filed some of the threads, and installed it to the spindal mount no problem. However getting it back up there was no fun. Jacking teh bottom arm up didnt do anything but raise teh spindle an inch before it raised the truck off of the jack stands. Had to get my wife to wedge in there and sit on the upper arm to get it back together.

Tomorrow I do the other side. I need to get a special wrench 'cause it looks like the castle on that side is gonna strip if I try to torque it off anymore.

Seems mine isnt going quite as easy as some... Byt anything to make my baby better.

Thanks for the advice all.