Loud "clunk" when shifting out of Park

[JoeU]

Hi all, this is my first time here. I've got a 99 VX and I'm having what I assume is a transmission problem. I've done some searching through the forum and I see that a lot of people have reported a loud clunking sound or hard shifting after they're already driving. I'm getting the clunking sound as well but it's happening when I shift out of Park into either Drive or Reverse or when I shift out of Reverse into a forward gear. I've noticed it for a while now but until recently it was never really serious enough that I was too worried about it. But within about the last month or so I've had some major work done. I had the rear end replaced as well getting new brakes all the way around. Since I got it back from the shop the other day I've noticed that the shifting noise seems a lot louder than it used to. I should mention that I'm not really mechanically inclined or knowledgable. So could this be related to the work I recently had done? Is this something I should worry about or is it something I can live with? Any comments would be greatly appreciated. Thanks.

[Zorak]

The symptoms you are describing are typically associated with worn U-joints; have those been checked?

[Ldub]

OR...did the person who replaced the rear end, properly tighten the bolts that hold the drive-shaft to the rear end ?
Crawl under & see if U can wiggle the rear drive-shaft up & down(same test for U-joints)...anything more than zero slop is not good.

[JoeU]

Don't know right now on either count. I'll see what I can find out in the morning. Thanks for the suggestions.

[WormGod]

This has always been pretty normal for my VX. Even after I lube up the joints and check over all drivetrain elements. Solid as can be. It's a clunk that comes and goes. I notice it more when the VX has been in Park on an incline. My impression is, expect SOME clunk, as this tranny is pretty solid and tends to do that. It *IS* a truck afterall. You should keep all joining members well lubed up to keep the clunk at a minimum though.

Having the rear end replaced could lend another set of issues though. If the clunk is more apparent after the work has been done. I would take it right back to the shop that did the work. And dont settle for some undercover *we dont want to work on it* excuse, heh.

[kelvin]

mine will also "clunk" out of and into park. I'm pretty sure its always done it... i havn't had any problems with the transmission or anything like that. i allways assumed it to be normal. just dropping into gear....