alloys???

[sgtbilko]

After many hours of surfing and searching, I think I may have found the wheels I've been looking for.
They're a clean 5 spoke design, no fuss - I'll post a pic soon.

They come in both 7x16's and 8.5x18's. The 16's have a zero or +13 off-set, whilst the 18's have zero or +30 off-set.

The dealer informs that both will happily bolt on a Trooper, Rodeo, Bighorn and Amigo, so I'm presuming stud pattern and centre bore will be ok.

I'm tempted to go for the 18's, but concerned that the 8.5' width might cause a problem.

If this is the case I'm happy to stick with 16's........
Can anyone advise on what combination of wheel and off-set I should go for? i.e 7x16 with zero or +13 off-set.

Advice appreciated,
Darryl

[majork]

I was able to get 8.5x16s, by MB Motoring, on nicely....I was going for 10x16s but it required too tall a tire....would have required a lift kit to make it happen....Calmini Products does have a 3" lift kit (future purchase)